sales01@cxflowmeter.com

Compressor lube oil flow meter, hydraulic oil flow meter, lube oil flowmeter for bearing lubrication and cooling

 

Actual analysis of bearing lubrication and cooling flow control in a hydraulic lubricating equipment company

 

1. Working condition analysis:

Medium: No. 46 hydraulic oil

Viscosity: 46cps

Flow: 2.5L-10L/H

Temperature and pressure: normal temperature pressure: 4kg

Power source: gear pump

Detection method: instantaneous flow monitoring

Display: configure digital display, 4-20ma output

Specific working conditions: It is used for the lubrication and cooling of compressor (centrifugal and screw compressors) components, and a flow meter is installed for
each oil inlet and oil return for detection.

 

2. Industry analysis:

 

       Why use a flow meter?

 

Hydraulic oil is used to lubricate and cool the cooling and bearing components on the compressor. The effectiveness of lubrication and cooling depends on whether the
flow rate of the lubricating oil is within the specified range. If it is too large or too small, the cooling and lubricating effect will be poor. For example, if the bearing is damaged
due to excessive wear, it will cause the compressor to fail to work properly and needs to be repaired. The maintenance cycle is long and the cost is high, and it will also
affect the normal production of the factory.

For specific suitable models and quotations, please contact winny:sales01@cxflowmeter.com